Chrysler Vehicle User Manual page 224

TJ
DISC BRAKE CALIPERS (Continued)
(6) Press piston into caliper bore by hand, use a
turn and push motion to work piston into seal (Fig.
21) .
Fig. 21 Caliper Piston Installation
1 - PISTON
2 - BOOT
(7) Press caliper piston to bottom of bore.
(8) Seat dust boot in caliper with Installer Tool
C-4842 and Tool Handle C-4171 (Fig. 22) .
Fig. 22 Piston Dust Boot Installation
1 - HANDLE C-4171
2 - INSTALLER C-4842
3 - DUST BOOT
(9) Replace caliper bleed screw if removed.
INSTALLATION
INSTALLATION - FRONT
(1) Clean brake shoe mounting ledges with wire
brush and apply light coat of Mopar multi-mileage
grease to surfaces (Fig. 23).
Fig. 23 Caliper Lubrication Points
1 - BUSHINGS
2 - CALIPER MOUNTING BOLTS
3 - MOUNTING LEDGES
(2) Install caliper by position notches at lower end
of brake shoes on bottom mounting ledge. Then
rotate caliper over rotor and seat notches at upper
end of shoes on top mounting ledge (Fig. 24).
Fig. 24 Caliper Installation
1 - TOP LEDGE
2 - BRAKESHOE TAB ON LEDGE OUTER SURFACE
3 - LEDGE SEATED IN BRAKESHOE NOTCH
4 - BOTTOM LEDGE
BRAKES - BASE 5 - 15