Chrysler Vehicle User Manual page 70

TJ
DOUBLE CARDAN UNIVERSAL JOINTS (Continued)
Fig. 23 REMOVE BEARING FROM YOKE
Fig. 24 REMOVE CENTERING KIT
(12) Press the remaining bearing caps out the
other end of the link yoke as described above to com-
plete the disassembly.
ASSEMBLY
CAUTION: All alignment marks on the link yoke and
propeller shaft yoke must be aligned during assem-
bled.
(1) Apply extreme pressure (EP) N.L.G.I. Grade 1
or 2 grease to inside of yoke bores.
(2) Fit a cross into the propeller shaft yoke (Fig.
25).
Fig. 25 INSTALL CROSS IN YOKE
(3) Place a bearing cap over the trunnion and
align the cap with the yoke bore (Fig. 26). Keep nee-
dle bearings upright in the bearing cap.
Fig. 26 INSTALL BEARING CAP
PROPELLER SHAFT 3 - 11