Ip Address; Monitor And Power On - RADVision Scopia XT1000 Administrator's Manual

Pressing
default auto mode.

IP Address

I cannot configure my IP address:
The system does not make calls when IPv6 support is enabled.
Select Administrator settings > Networks > Preferences > General. Disable and then enable
again Ipv6 support.

Monitor and Power On

A blank screen appear, or I cannot turn on the Codec Unit:
The monitor randomly blinks at system startup.
I cannot hear the audio output from the HDMI monitor:
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
and 0 simultaneously on the Remote Control Unit, brings the system back to the
•
If this icon appears in the system area of the GUI, there is a bad LAN cable connection.
Make sure the LAN cable is connected properly at both ends.
•
In the Main Menu page, press
setup 6/6, and re-configure the IP address.
•
Make sure the power cord of the Codec Unit is connected properly at both ends.
•
Verify the monitor's power cord is connected properly at both ends.
•
Check that the monitor power switch is set to ON.
•
Make sure the Codec Unit's LED is on. If the LED is blinking, press
Unit.
•
Make sure the Codec Unit output is properly connected to the monitor input. Did you connect
with a HDMI/DVI cable? Make sure the HDMI/DVI cable is connected properly at both ends.
•
Press repeatedly to confirm that the monitor is set to the correct source and receiving an
input signal.
•
Disconnect and reconnect the Microphone Pod(s).
•
Disconnect and reconnect the HDMI monitor.
•
Select Administrator settings > I/O Connections > Monitor > General and reset the blinking
monitor.
•
Disconnect and reconnect the Microphone Pod.
•
Disconnect and reconnect the HDMI monitor.
•
Select Administrator settings > I/O Connections > Monitor > General and reset the monitor
without audio.
Quick setup on the Remote Control Unit. Navigate to Quick
on the Remote Control
'Troubleshooting' | 71