Configuring The Camera(S) - RADVision Scopia XT1000 Administrator's Manual

Step 3
In the General page set the fields as required.
Field Name
Default camera
Driver
Camera control by far site
Bring back to place
Name
Step 4
Press

Configuring the Camera(s)

You may also access this page from a previous screen in the configuration.
Procedure
Step 1
In the Administrator settings menu select I/O connections.
Step 2
Scroll to Cameras.
Step 3
Select the HD1 or HD2 page.
Step 4
Set the fields as required.
Field Name
Enable (HD1 page)
Enable (HD2 page)
Moving (PTZ)
Name
White balance mode In case of lighting issues in the room, enables to select the appropriate
Step 5
Press
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Description
Specifies to which input of the Codec Unit the main camera is
connected: HD-CAM 1, HD-CAM 2, DVI. The default camera is
automatically activated when the system powers up.
Sets the camera driver for the connected camera: SCOPIA
XT1000 Standard Camera or SCOPIA XT1000 Sony Camera.
Enables/disable control of my camera(s) by the remote terminal.
If enabled, the system stores camera positions when the camera
is turned off.
Enter the camera's name. The selected name will appear in the
system area of the display in addition to the camera icon.
Save.
Description
You cannot change this setting.
Enables/disables HD2. If an additional camera is not used, we
recommend to disable this field.
Enables/disables camera's Plan, Tilt, Zoom.
Enter the camera's name. The selected name will appear in the system
area of the display in addition to the camera icon.
white balance mode. If set to Automatic, the camera adjusts
automatically to room lighting. If set to Customize, a Calibration button
appears on the display, allowing you to calibrate white balance.
Save.
'Initial Configuration' | 23