Resolving IP Address Problems
Problem
Solution
Solution
Problem
Solution
RADVISION | Administrator Guide for SCOPIA XT5000 Series Version 3.0
Cannot configure the IP address.
If the icon for no network connection
functioning. Make sure the LAN cable is connected properly at both ends, and the network
port is functioning correctly.
Redefine the IP address:
1.
From the Main menu, select Configure.
2.
Press Next several times until the Configure TCP/IP screen appears.
3.
Enter the IP address.
4.
Select Next.
5.
Select Done.
The system does not make calls when IPv6 support is enabled.
Perform this procedure:
1.
Access the SCOPIA XT Series web interface.
2.
In the Administrator settingstab, select Networks > Preferences > General.
appears, the LAN cable connection is not
Figure 3-9
Configuring IP address
Troubleshooting | 34