RADVision Scopia XT1000 Administrator's Manual page 53

Step 5
If a gatekeeper is not present in the network, report the IP number of the gateway. If a gatekeeper
is present, this number is not needed.
Note:
Step 6
After this setup, the user can easily place an ISDN call (as explained in the User Guide).
If the user wants to change the Rate of the call, he may use the Advanced Options page in the
Direct Call GUI, and select the pre-defined rate. When the SCOPIA gateway is used, the Codec
Unit will automatically detect the rate used to place the call.
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
In Solution mode (when a gatekeeper and iVIEW are available), the Codec Unit must be
registered with the gatekeeper.
Figure 2-11
Figure 2-10 Basic Call
Advanced Call
'Initial Configuration' | 47