Configuring Mtu Parameters - RADVision Scopia XT1000 Administrator's Manual

Procedure
Step 1
In the Administrator settings menu select Networks.
Step 2
Scroll to GLAN/LAN.
Step 3
Select the Addresses page.
Step 4
Set the fields as required.
Field Name
Enable
Max. bandwidth rx (KB)
Max. bandwidth tx (KB)
Step 5
Press

Configuring MTU Parameters

Settings are for GLAN and LAN connections.
The setting should match the network settings to avoid fragmentation. If the system or the other
party (another endpoint or a conferencing server)uses packets that are larger than the MTU size,
packets will be dropped and packet loss will occur. To avoid this loss, decrease the MTU. If packets
are smaller than the MTU size, increase the MTU.
A maximum and minimum value are displayed in this page. The maximum and minimum values
depend on selecting IPv4 or IPv6. (See
the MTU size is set by default to 1360 octets, and it may have these ranges:
Procedure
Step 1
In the Administrator settings menu select Networks.
Step 2
Scroll to GLAN/LAN.
Step 3
Select the Parameters page.
Step 4
Set the field as required.
Field Name
MTU
Step 5
Press
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Save.
•
The minimum allowed for IPv4 is 576 octets.
•
The minimum allowed for IPv6 is 1280 octets.
•
The maximum allowed for both is 1500 octets
Setting
Sets the maximum size of each data packet.
Save.
Setting
Enables/disables the bandwidth option.
Indicates the maximum receive bandwidth.
Indicates the maximum transmit bandwidth.
General Network Settings page 32.) Both for IPv4 and IPv6
'Initial Configuration' | 40