Port Storm-Control Broadcast Enable - Allied Telesis AT-8000S Cli Reference Manual

Parameters
•
unknown-unicast — Specifies also counting unknown unicast packets.
Default Configuration
Multicast packets are not counted.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
This command is relevant to FE devices only.
To control multicasts storms, use the port storm-control broadcast enable and port storm-control broadcast
rate commands.
Example
The following example enables counting broadcast and multicast packets on Ethernet port 2/e3.
Console(config)# interface ethernet 2/e3
Console(config-if)# port storm-control include-multicast

port storm-control broadcast enable

The port storm-control broadcast enable Interface Configuration (Ethernet) mode command enables broadcast
storm control. To disable broadcast storm control, use the no form of this command.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Default Configuration
Broadcast storm control is disabled.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast rate Interface Configuration (Ethernet) mode command, to set the
maximum allowable broadcast rate.
For FE devices, use the port storm-control include-multicast Interface Configuration (Ethernet) mode
command to enable counting multicast packets and optionally unknown unicast packets in the storm control
calculation.
For GE devices,use the port storm-control include-multicast Global Configuration mode command to enable
counting multicast packets in the storm control calculation.
Ethernet Configuration Commands
Page 83