Show Stack - Allied Telesis AT-8000S Cli Reference Manual

Allied Telesyn AT-8000S Switch
CLI Reference Guide
The command takes effect only after resetting the device.
Example
This example changes Unit Number 6 to Unit Number 5. The command takes effect only after resetting the deivce.
Console# config
Console(config)# stack change unit-id 6 to 5

show stack

Note
This command is operational in the AT-8000S/24, AT-8000S/24POE, AT-8000S/48 and AT-8000S/
48POE devices.
The show stack User EXEC mode command displays information about the status of a stack.
Syntax
show stack [unit unit]
Parameters
•
unit— Specifies the number of the unit. (Range: 1-6)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command is not relevant to standalone devices.
Example
The following example displays stack status.
Console> show stack
Unit Address
---- -----------------
1 00:00:b0:87:12:11
2 00:00:b0:87:12:13
4 00:00:b0:87:12:14
5 00:00:b0:87:12:15
6 00:00:b0:87:12:16
Configured order: Unit 1 at Top, Unit 2 at bottom
Software Master
-------- ------
1.0.0.0 Enabled
1.0.0.0 Enabled
1.0.0.0
1.0.0.0
1.0.0.0
Page 238
Uplink Downlink
------ --------
2 3
1 4
3 5
4 6
5 7
Status
------
Slave
Master
Slave
Slave
Slave