Chapter 6.Ethernet Configuration Commands; Interface Ethernet; Interface Range Ethernet - Allied Telesis AT-8000S Cli Reference Manual

Allied Telesyn AT-8000S Switch
CLI Reference Guide
Chapter 6. Ethernet Configuration Commands

interface ethernet

The interface ethernet Global Configuration mode command enters the interface configuration mode to configure
an Ethernet type interface.
Syntax
interface ethernet interface
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables configuring Ethernet port 5/e18.
Console(config)# interface ethernet 5/e18

interface range ethernet

The interface range ethernet Global Configuration mode command configures multiple Ethernet type interfaces
at the same time.
Syntax
interface range ethernet {port-range | all}
Parameters
•
port-range — List of valid ports. Where more than one port is listed, separate nonconsecutive ports with a
comma and no spaces, use a hyphen to designate a range of ports and group a list seperated by commas in
brackets.
•
all — All Ethernet ports.
Default Configuration
This command has no default configuration.
Page 68