Browse Router Port; Port Access Control; Authenticator State - Allied Telesis AT-9724TS Installation And User Manual

The user may search the IGMP Snooping Forwarding Table by VLAN Name using the top left hand corner Search.
The following fields can be viewed:
Parameter
VLAN Name
Source IP
Multicast Group
Port Map

9-10 Browse Router Port

This displays which of the Switch's ports are currently configured as router ports.A router port configured by a user (using the console or Web-based
management interfaces) is displayed as a static router port, designated by S.A router port that is dynamically configured by the Switch is designated by D.

9-11 Port Access Control

The following screens are used to monitor 802.1x statistics of the Switch, on a per port basis.To view the Port Access Control screens, open the monitoring
folder and click the Port Access Control folder.There are six screens to monitor.
Note: 802.1X must be enabled under Configuration > Advanced Settings.

Authenticator State

The following section describes the 802.1X Status on the Switch.To view the Authenticator State, click Monitoring > Port Access Control >
Authenticator State.
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch
Description
The VLAN Name of the multicast group.
The Source IP address of the multicast group.
The IP address of the multicast group.
These are the ports where the IP multicast packets are being forwarded to.
Figure 9- 21. Browse Router Port window
Figure 9- 22.Authenticator State window – Port Based 802.1x
171