Allied Telesyn AT-8000S Switch
CLI Reference Guide
qos trust (Interface)
The qos trust Interface Configuration (Ethernet, port-channel) mode command enables each port trust state while
the system is in the basic QoS mode. To disable the trust state on each port, use the no form of this command.
Syntax
qos trust
no qos trust
Default Configuration
qos trust is enabled on each port.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures Ethernet port 1/e15 to the default trust state.
console(config)# interface ethernet 1/e15
console(config-if) qos trust
qos cos
The qos cos Interface Configuration (Ethernet, port-channel) mode command defines the default CoS value of a
port. To return to the default configuration, use the no form of this command.
Syntax
qos cos default-cos
no qos cos
Parameters
•
default-cos — Specifies the default CoS value of the port. (Range: 0 - 7)
Default Configuration
Default CoS value of a port is 0.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
If the port is trusted, the default CoS value of the port is used to assign a CoS value to all untagged packets
entering the port.
Page 142