Show Dot1X Users - Allied Telesis AT-8000S Cli Reference Manual

Username
Quiet period
Tx period
Max req
Supplicant timeout
Server timeout
Session Time
MAC address
Authentication Method
Termination Cause
State
Authentication success
Authentication fails

show dot1x users

The show dot1x users Privileged EXEC mode command displays active 802.1X authenticated users for the
device.
Syntax
show dot1x users [username username]
Parameters
•
username — Supplicant username (Range: 1-160 characters)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
The username representing the identity of the Supplicant. This field shows the
username in case the port control is auto. If the port is Authorized, it shows the
username of the current user. If the port is unauthorized it shows the last user
that was authenticated successfully.
The number of seconds that the device remains in the quiet state following a
failed authentication exchange (for example, the client provided an invalid
password).
The number of seconds that the device waits for a response to an Extensible
Authentication Protocol (EAP)-request/identity frame from the client before
resending the request.
The maximum number of times that the device sends an Extensible
Authentication Protocol (EAP)-request frame (assuming that no response is
received) to the client before restarting the authentication process.
Time in seconds the switch waits for a response to an EAP-request frame from
the client before resending the request.
Time in seconds the switch waits for a response from the authentication server
before resending the request.
The amount of time the user is logged in.
The supplicant MAC address.
The authentication method used to establish the session.
The reason for the session termination.
The current value of the Authenticator PAE state machine and of the Backend
state machine.
The number of times the state machine received a Success message from the
Authentication Server.
The number of times the state machine received a Failure message from the
Authentication Server.
Page 291
802.1x Commands