Show Ports Storm-Control - Allied Telesis AT-8000S Cli Reference Manual

Example
The following example configures the maximum storm control broadcast rate at 900 Kbits/Sec on Ethernet
port 1/e5 of a FE device.
Console(config)# interface ethernet 1/e5
Console(config-if)# port storm-control broadcast rate 900

show ports storm-control

The show ports storm-control User/Privileged EXEC mode command displays the storm control configuration.
show ports storm-control [interface]
Parameters
•
interface — A valid Ethernet port. (Full syntax: unit/port)
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the storm control configuration.
Console# show ports storm-control
Port State
---- --------
1/e1 Enabled
2/e1 Enabled
3/e1 Disabled
Rate [Kbits/Sec] Included
---------------- --------------------------------------
70 Broadcast, Multicast, Unknown Unicast
100 Broadcast
100 Broadcast
Page 85
Ethernet Configuration Commands