Siemens SINAMICS G150 Operating Manual page 87

11/03
6.2.2.1 Operation Screen Menu
Description
The operation screen displays the most important status variables for the cabinet
units:
It displays the operating status of the drive, the direction of rotation, the time, as
well as four drive variables (parameters) numerically and two in the form of a bar
display for continuous monitoring.
You can call up the operation screen in one of three ways:
1. After the power supply has been switched on and the system has ramped up.
2. If you do not make any entries for two minutes, the system calls up the
operation screen automatically.
3. By pressing the MENU key twice and then F5 OK
If a fault occurs, the system automatically displays the fault screen (see Section
6.2.4).
In LOCAL control mode, you can choose to enter the setpoint numerically (F2:
setpoint).
Settings
When you choose Settings – Define operation screen, you can adjust the type of
display and the values displayed as required.
See Section 6.2.2.3
SINAMICS G150
Operating Manual
Operation
N SET= 1450.000min¹ F_OUT=
P_ACT= 235.0kW
N_ACT[min¹]
1450.0 0%
I_ACT[A ]
450.0 0%
F1 F2 F3
12:25:30 S
50.0Hz
Vdc = 620.0V
50% 100%
50% 100%
F4 F5
Operation
6-5