Siemens SINAMICS G150 Operating Manual page 205

11/03
Upgrading the Firmware for the Cabinet Unit Components
Access level "Expert"
p7828 = 2
p7829 = 1
p7828 = 3
p7829 = 1
POWER ON
Fault during the upgrade
Faults that occur while the firmware is being upgraded are indicated by fault F1005 and a
fault value.
Fig. 11-2 Upgrading the cabinet unit firmware
NOTE
Once the firmware has been upgraded, the firmware for the operator panel must
also be upgraded.
SINAMICS G150
Operating Manual
Set the "Expert" access level on the operator panel
<Key pushbutton> - <Access level> - Enter the activation code
"47"
Select the node number of the power section
The node number of the power section is "2".
Upgrade the firmware
This process lasts a few minutes. It has been completed
successfully when p7829 automatically switches to "0".
Select the node number of the customer terminal block
The node number of the customer terminal block (-A60) is "3".
Upgrade the firmware
This process lasts a few minutes. It has been completed
successfully when p7829 automatically switches to "0".
POWER ON
To activate the new firmware, switch the power supply off and
then on.
Maintenance and Servicing
11-9