Siemens SINAMICS G150 Operating Manual page 145

11/03
---
OPT
Green
(option)
Red
MOD ---
(SIMOTION)
Green
Customer Terminal Block TM 31 (-A60)
Table 10-2 Description of the LEDs
LED Color
READY ---
Green
Orange
Red
Red
Green
CIB – Converter Interface Module (-U1)
Table 10-3 Description of the LEDs
LED Color
READY ---
Green
Orange
Red
DC LINK ---
Yellow
Red
SINAMICS G150
Operating Manual
OFF Electronics power supply outside the
permissible tolerance range
Control unit 320 is not ready for operation
No Option Board
Continuously lit Option is ready for operation
Flashing 0.5 Hz Depends on the board option used
Continuously lit At least one fault is present in the board
Board option not ready for operation (e.g. after
power-on)
OFF Reserved
Continuously lit Reserved
State
OFF Electronics power supply out of permissible
tolerance range
Continuously lit Customer terminal block ready for operation
Continuously lit DRIVE CliQ communication is being
established.
Continuously lit Fault present
Flashing 2 Hz Firmware is being downloaded.
Component recognition via LED is activated
(p0154)
State
Off Electronics power supply out of permissible
tolerance range
Continuously lit Motor Module ready for operation
Continuously lit DRIVE CliQ communication is being
established.
Continuously lit At least one fault is present.
Off Electronics power supply out of permissible
tolerance range
Continuously lit DC link voltage in the permissible tolerance
range (only when the Motor Module is ready for
operation)
Continuously lit DC link voltage outside the permissible
tolerance range (only when the Motor Module is
ready for operation)
Diagnosis / Faults and Alarms
Description
Description
10-3