Reload; Set Default; Setup; Language - Digitalchina Networks DCS-3950 series Manual

DCS-3950 series Ethernet switch manual

5.1.9 reload

Command: reload
Function: Warm reset the switch.
Command mode: Admin Mode
Usage Guide: The switch can be rebooted through this command without resetting the
power.

5.1.10 set default

Command: set default
Function: Reset the switch to factory settings.
Command mode: Admin Mode
Usage Guide: The switch will be reset to the factory state through this command. All the
configurations will be reset after system reboot.
Notice: the write command should be issued after the above command, in order to save
the results. Switch configurations will be reset to factory mode after system reboot.
Example:
Switch#set default
Are you sure? [Y/N] = y
Switch#write
Switch#reload

5.1.11 setup

Command: setup
Function: Enter the Setup Mode of the switch.
Command mode: Admin Mode
Usage Guide: Configuration such as Ip addressed and web services can be done through
this command in the Setup mode.

5.1.12 language

Command: language {chinese|english}
Function: Set the language for displaying the help information.
Parameter: Chinese for Chinese display; English for English display.
Command mode: Admin Mode
Default: The default setting is English display.
Usage Guide: Language for the system can be customized through this command
according to the requirement. System language will be reset to English by default.
42