Dot1X Eapor Enable; Dot1X Enable - Digitalchina Networks DCS-3950 series Manual

Only the authentication request initialed by the users in the dot1x address filter table will
be accepted, the rest will be rejected.
Example: Add MAC address 00-01-34-34-2e-0a to the filter table of Ethernet 0/0/5.
Switch(Config)#dot1x accept-mac 00-01-34-34-2e-0a interface ethernet 0/0/5
14.2.2.5 dot1x bpdu-forward enable
Command: dot1x bpdu-forward enable
no dot1x bpdu-forward enable
Function: Enable the forwarding of 802.1x authentication on the switch. If no is put in
front of this command, the forwarding will be disabled.
Command mode: Global Mode.
Default: 802.1x authentication forwarding on the switch is disabled by default.
Function: If
Example: Enable forwarding of 802.1x authentication messages.
Switch(Config)#dot1x bpdu-forward enable

14.2.2.6 dot1x eapor enable

Command: dot1x eapor enable
no dot1x eapor enable
Function: Enable the EAP relay authentication function in the switch; the 'no dot1x
eapor enable' command sets EAP local end authentication.
Command mode: Global Mode
Default: EAP relay authentication is used by default.
Usage Guide:
The switch and RADIUS may be connected via Ethernet or PPP. If an Ethernet
connection exists between the switch and RADIUS server, the switch needs to
authenticate the user by EAP relay (EAPoR authentication); if the switch connects to the
RADIUS server by PPP, the switch will use EAP local end authentication (CHAP
authentication). The switch should use different authentication methods according to the
connection between the switch and the authentication server.
Example: Set EAP local end authentication for the switch.
Switch(Config)#no dot1x eapor enable

14.2.2.7 dot1x enable

Command: dot1x enable
no dot1x enable
Function: Enable the 802.1x function in the switch and ports: the 'no dot1x enable'
command disables the 802.1x function.
Command mode: Global Mode and Interface Mode.
Default: 802.1x function is not enabled in global mode by default; if 802.1x is enabled
under Global Mode, 802.1x will not be enabled for the ports by default.
DCS-3950 series Ethernet switch manual
230