Application Example - Digitalchina Networks DCS-3950 series Manual

DCS-3950 series Ethernet switch manual
waiting time, the switch resends the request packet or sets the server as invalid according
to the current conditions.
Example: Set the RADIUS authentication timeout timer value to 30 seconds.
Switch(Config)# radius-server timeout 30
14.2.2.29 radius-server realtime-accounting timer
Command：radius-server realtime-accounting timer <minute>
Function：Set the interval of sending accounting messages. the no operation of
this command will reset to the default configuration.
Parameters：<seconds> is the interval of sending accounting update messages, in
seconds, ranging from 60 to 3600.
Command mode：Global Mode.
Default：The default interval of sending accounting update messages is 300 seconds.
Usage Guide: None.
Example: Configure to send accounting messages every 10 minutes.
Switch(Config)# radius-server realtime-accounting timer 10
14.3 802.1x Application Example
10.1.1.2
10.1.1.1
Radius Server
10.1.1.3
Fig 14-2 IEEE802.1x Configure Topology of the example
The computer is connected to the port 0/0/2 of the switch, and the IEEE802.1
authentication function is enabled on the port, which adopts MAC-address-based
authentication as the access method by default. The IP address of the switch is 10.1.1.2,
and all the ports other than port 0/0/2 are connected to RADIUS authentication server, the
IP address of which is 10.1.1.3. By default the authentication and cost-counting ports are
240