Chapter 16 Am Configuration; Am Introduction; Am Pool; Am Configuration - Digitalchina Networks DCS-3950 series Manual

Chapter 16 AM Configuration

16.1 AM Introduction

AM（access management） compares the information of the received data message
( source IP address or source IP + source MAC ) with the configured hardware address
pool, if founds a match, forwards the message, if not, dumps it.

16.2 AM pool

AM pool is an address list, each entry of this address list corresponds with a user.
Each entry contains address information and its corresponding port. There two kinds of
address information：
IP address(ip-pool), specifies the user's source IP address information of the port.
MAC-IP address (mac-ip pool)，specifies the user's source MAC address and source
IP address information of the port.
The default AM action is to deny. When the AM is enabled, the AM module will deny
all the IP messages( only allows the source addresses of the members of the IP pool),
when AM is disabled, it will delete all the address pools.

16.3 AM Configuration

16.3.1 AM Configuration Task List

1. Enable AM
2. Configure IP address on an interface
3. Configure MAC-IP address on an interface
4. Delete all the address pools
1． Enable AM
Command
Global configuration mode
am enable
no am enable
2． Configure IP address on an interface
DCS-3950 series Ethernet switch manual
Explanation
Enable the AM access management
function to configure address pools. The
'no am enable' command will disable AM
and delete all the address pools.
283