Dcscm Command List - Digitalchina Networks DCS-3950 series Manual

3. Configuration of mulicast policy
Mulicast policy satisfies the demand of special users by designating priority for
specified multicast data. What calls for attention is that multicast data can only be taken
special care when it is transmitted on TRUNK . The following is the command to configure
(set a priority for the specified multgicast):
Command
Global configuration mode
[no] ip multicast policy <source>
<source-wildcard> <destination>
<destination-wildcard> cos
<priority>

13.2.2 DCSCM Command List

13.2.2.1 access-list (Multicast Source Control)）
Command: access-list <5000-5099> {deny|permit} ip {{<source>
<source-wildcard>}|{host <source-host-ip>}|any} {{<destination>
<destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
no access-list <5000-5099> {deny|permit} ip {{<source>
<source-wildcard>}|{host <source-host-ip>}|any} {{<destination>
<destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
Function: Configure source control multicast access-list; the 'no access-list
<5000-5099> {deny|permit} ip {{<source> <source-wildcard>}|{host
<source-host-ip>}|any} {{<destination> <destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}' command deletes the access-list.
Parameter: <5000-5099>: source control access-list number.
{deny|permit}: deny or permit.
source address wildcard character.
<source-host-ip>: multicast source host address.
<destination>: multicast destination address.
<destination-wildcard>: multicast destination address wildcard character.
<destination-host-ip>: multicast destination host address.
Default: None
Command mode: Global Mode
Usage Guide: ACL of Multicast source control list item is controlled by specifical ACL
number from 5000 to 5099, the command applies to configure this ACL. ACL of Multicast
source control only needs to configure source IP address and destination IP address
controlled (group IP address), the configuration mode is basically the same to other
DCS-3950 series Ethernet switch manual
<source>: multicast source address.<source-wildcard>: multicast
Explantation
Configure the multicast policy, set priority for
source within a special range. The range of
priority is <0-7>.
214