Dcscm Troubleshooting; Dcscm Debug And Monitor Command List - Digitalchina Networks DCS-3950 series Manual

it will be at priority 4(usually it is a high priority, the higher might be protocol data, but if we
set higher priority, when there is too much multicast data, may cause abnormal behavior
of the switch protocol)

13.4 DCSCM Troubleshooting

13.4.1 DCSCM Debug and Monitor Command List

13.4.1.1 show ip multicast source-control access-list
Command: show ip multicast source-control access-list
show ip multicast source-control access-list <5000-5099>
Function: Display the configured source control multicast ACL.
Parameters： <5000-5099>: ACL ID
Default：None.
Command mode：Admin Mode
Example:
Switch#sh ip multicast source-control access-list
access-list 5000 permit ip 10.1.1.0 0.0.0.255 232.0.0.0 0.0.0.255
access-list 5000 deny ip 10.1.1.0 0.0.0.255 233.0.0.0 0.255.255.255
13.4.1.2 show ip multicast destination-control access-list
Command: show ip multicast destination-control access-list
show ip multicast destination-control access-list <6000-7999>
Function： Display the configured destination control multicast ACL,
Parameters： <6000-7999>: ACL ID.
Default：None.
Command mode：Admin Mode
Usage Guide: The command displays destination control multicast access-list of
configuration.
Example:
Switch#sh ip multicast destination-control acc
access-list 6000 deny ip any-source any-destination
access-list 6000 deny ip any-source host-destination 224.1.1.1
access-list 6000 deny ip host-source 2.1.1.1 any-destination
access-list 6001 deny ip host-source 2.1.1.1 225.0.0.0 0.255.255.255
access-list 6002 permit ip host-source 2.1.1.1 225.0.0.0 0.255.255.255
access-list 6003 permit ip 2.1.1.0 0.0.0.255 225.0.0.0 0.255.255.255
DCS-3950 series Ethernet switch manual
220