Configuration Command List - Digitalchina Networks DCS-3950 series Manual

radius-server accounting host
<IPaddress> [[port {<portNum>}]
[primary]]
no radius-server accounting host
<IPaddress>
3) Configure RADIUS Service parameters.
Command
Global Mode
radius-server dead-time
<minutes>
no radius-server dead-time
radius-server retransmit <retries>
no radius-server retransmit
radius-server timeout <seconds>
no radius-server timeout
radius-server realtime-accounting
timer <minute>
14.2.2 802.1x Configuration Command List
14.2.2.1 aaa enable
Command: aaa enable
no aaa enable
Function: Enable the AAA authentication function in the switch; the 'no AAA enable'
command disables the AAA authentication function.
Command mode: Global Mode
Parameters: None.
Default: AAA authentication is not enabled by default.
Usage Guide: The AAA authentication for the switch must be enabled first to enable IEEE
802.1x authentication for the switch.
Example: Enable AAA function for the switch.
Switch(Config)#aaa enable
14.2.2.2 aaa-accounting enable
Command: aaa-accounting enable
no aaa-accounting enable
Function: Enable the AAA accounting function in the switch: the 'no aaa-accounting
enable' command disables the AAA accounting function.
DCS-3950 series Ethernet switch manual
Specifies the IP address or IPv6 address and
listening port number for RADIUS accounting
server; the 'no radius-server authentication
host <IPaddress>' command deletes the
RADIUS server
Explanation
Configures the restore time when RADIUS
server is down; the 'no radius-server
dead-time' command restores the default
setting.
Configures the re-transmission times for
RADIUS; the 'no radius-server retransmit'
command restores the default setting
Configures the timeout timer for RADIUS
server; the 'no radius-server timeout'
command restores the default setting.
Set the realtime cost-counting update
interval.
228