Displayed Information
C - connected
S – static
R - RIP derived
O - OSPF derived
A- OSPF ASE
B- BGP derived
D - DVMRP derived
Destination
Mask
Nexthop
Interface
Preference
25.2 ARP
25.2.1 Introduction to ARP
ARP (Address Resolution Protocol) is mainly used in IP address to Ethernet MAC
address resolution. DCS-3950 series supports static configuration.
25.2.2 ARP Configuration
25.2.2.1 ARP Configuration Task List
1. Configure static ARP
1. Configure static ARP
Command
arp <ip_address> <mac_address>
no arp <ip_address>
DCS-3950 series Ethernet switch manual
Notes
Directly connected routing.
Static routing, which is manually configured.
RIP routing, which is learned by Lay 3 switches through RIP
protocol.
OSPF routing, which is learned by Lay 3 switches, through the
OSPF protocol.
OSPF-ASE routing.
BGP routing
DVMRP routing
Destination network
Destination network mask.
IP address of next hop.
The interface of Layer 3 switches for forwarding the packets to
next hop.
Priority of the routing entry. If packets can reach the
destination network through more than one route, the route
with the highest priority will be chosen.
Explanation
Configure a static ARP entry;
<ip_address>' command deletes a static
ARP entry.
the 'no arp
382