Clustering Configuration Command List - Digitalchina Networks DCS-3950 series Manual

cluster auto-add enable
no cluster auto-add enable
cluster holdtime < second>
no cluster holdtime
cluster heartbeat <interval>
no cluster heartbeat
clear cluster candidate-table
4. Configure attributes of the cluster in the candidate switch
Command
Global Mode
cluster register timer <timer-value>
no cluster register timer
5. Remote cluster network management
Command
Admin Mode
rcommand member <mem-id>
rcommand commander
cluster reset member<mem-id>
cluster update member <mem-id>
<src-url> <dst-url> [ascii | binary]

6.2.2 Clustering Configuration Command List

6.2.2.1 cluster run
Command: cluster run
no cluster run
Function: Enable the clustering mode. While no is to disable the command.
Parameters: None.
Command mode: Global Mode.
Default: Clustering is enabled by default.
Usage Guide: This command is used to start the clustering service. Clustering
commands can be configured only if clustering is disabled.
Example: Disable the clustering service on the switch.
DCS-3950 series Ethernet switch manual
Enable or disable adding newly discovered
candidate switch to the cluster
Set holdtime of heartbeat of the cluster
Set interval of sending heartbeat packets
among the switches of the cluster
Clear the list of candidate switches
discovered by the commander switch
Explanation
Set interval of sending cluster register
packet
Explanation
In the commander switch, this command is
used to configure and manage member
switches.
In the member switch, this command is
used to configure the member switch itself.
In the commander switch, this command is
used to reset the member switch.
In the commander switch, this command is
used to remotely upgrade the member
switch.
108