Port Configuration Example - Digitalchina Networks DCS-3950 series Manual

only or choose a port with greater throughput as the destination port.

7.3 Port Configuration Example

Use default VLAN1 since VLAN is not configured on all of the switches.
Switch
SW1
SW2
SW3
The configurations are listed below：
SW1：
Switch1(Config)#interface ethernet 0/0/7
Switch1(Config-Ethernet0/0/7)#speed-duplex force10-full
SW2：
Switch2(Config)#interface ethernet 0/0/8-9
l
Switch2(Config-Port-Range)#speed-duplex force10-full
Switch2(Config-Port-Range)#exit
Switch2(Config)#interface ethernet 0/0/24
Switch2(Config-Ethernet0/0/24)#speed-duplex force100-full
Switch2(Config-Ethernet0/0/24)#exit
Switch2(Config)#monitor session 1 source interface ethernet 0/0/8-9
Switch2(Config)#monitor session 1 destination interface ethernet 0/0/24
SW3：
Switch3(Config)#interface ethernet 0/0/10
Switch3(Config-Ethernet0/0/10)#speed-duplex force10-full
DCS-3950 series Ethernet switch manual
Fig 7-2 Port Configuration Example
Port
0/0/7
0/0/8-9
0/0/24
0/0/10
Attributes
10M/full
10M/full,mirror source port
100M/full,mirror destinationport
10M/full
132