Dot1Q-Tunnel Command List - Digitalchina Networks DCS-3950 series Manual

1. Configure the dot1q-tunnel function on the ports
2. Configure the type of protocol (TPID) on the ports
3. Configure the dot1q-tunnel type of the port.
1. Configure the dot1q-tunnel function on the ports
Command
Port mode
dot1q-tunnel enable
no dot1q-tunnel enable
2. Configure the type of protocol (TPID) of the port
Command
Port mode
dot1q-tunnel tpid {8100|9100|9200}
3. Set the dot1q-tunnel type of the port
Command
Interface configuration mode
switchport dot1q-tunnel mode {customer
|uplink}
no switchport dot1q-tunnel

9.3.3 Dot1q-tunnel Command List

9.3.3.1 dot1q-tunnel enable
Command: dot1q-tunnel enable
no dot1q-tunnel enable
Function: Set the access port of the switch to dot1q-tunnel mode; the 'no dot1q-tunnel
enable' command restores to default.
Parameter: None.
Commandmode: Global Mode.
Default: Dot1q-tunnel function disabled on the port by default.
Usage Guide: The switch can use dot1q-tunnel function after enable this command.
Example: Enable dot1q-tunnel function
Switch(Config)#dot1q-tunnel enable
9.3.3.2 dot1q-tunnel tpid
Command: dot1q-tunnel tpid {8100|9100|9200}
DCS-3950 series Ethernet switch manual
Explanation
Enter/exit the dot1q-tunnel mode on
the ports.
Explanation
Configure the type of protocol on
the ports.
Explanation
Set the dot1q-tunnel type of the
port
162