Web Interface - Digitalchina Networks DCS-3950 series Manual

command!' error if only 'sh r' is entered, as Shell is unable to tell whether it is 'show r'
or 'show running-config'. Therefore, Shell will only recognize the command if 'sh ru' is
entered.

4.2.2 Web Interface

The Web configuration interface has three parts: the upper part, the bottom left part
and the bottom right part.
The upper part is a picture of the front panel of a DCS-3950 series switch, which can
show the connection state of each port via the LEDs on the panel. If users click the port on
the picture of the front panel, the statistic traffic information of each port will be displayed
at the bottom right part of the Web configuration interface.
The bottom left part of the Web configuration interface is the main menu, with which
users can configure, control and maintain the switch, monitor ports and so on. The bottom
right part is used to display information and to interact with users. When the users click the
upper part or the bottom left part, the bottom right part will show the configuration interface
of the corresponding menu(submenu), then, the users can configure the switch as they
want to. To know more about the parameters appeared in the configuration interface,
please refer to the configuration introduction in relative chapters.
Tips on using the Web Configuration Interface
Tip 1
IE6.0 or later/800*600 is recommened, and JavaScript is required to be enabled.
Tip 2
To guarantee the validity of the operation of CGI programs, the brower is required to read
DCS-3950 series Ethernet switch manual
37