Management Via Http - Digitalchina Networks DCS-3950 series Manual

telnet-user <user> password {0|7} <password>
Assume a authorized user in the switch has a username of 'test', and password of 'test',
the configuration procedure should be like the following:
Switch >en
Switch#config
Switch(Config)#telnet-user test password 0 test
Enter valid login name and password in the Telnet configuration interface, Telnet user
will be able to enter the switch's CLI configuration interface. The commands used in the
Telnet CLI interface after login are the same as in that in the Console interface.

4.1.2.2 Management via HTTP

To manage the switch via HTTP, the following conditions should be meet:
1) Switch has an IP address configured;
2) The host IP address and the switch's VLAN interface IP address is in the same
network segment.
3) If not 2), Telnet client can connect to an IP address of the switch via other devices,
such as a router.
Similar to management via Telnet, as soon as the host succeeds to ping an IP
address of the switch and to type the right login password, it can access the switch via
HTTP. The configuration list is as below:
Step 1: Configure the IP addresses for the switch and start the HTTP function on the
switch.
For configuring the IP address on the switch through out-of-band management, see
DCS-3950 series Ethernet switch manual
Fig 4-7 Telnet Configuration Interface
28