Exiting Setup Configuration Mode - Digitalchina Networks DCS-3950 series Manual

Enable SNMP-server? (y/n) [y]:
Type 'y' and press Enter, or just press Enter to enable SNMP service, type 'n' and
press Enter to disable SNMP service. The SNMP configuration menu appears.
Select '4' in the SNMP configuration menu and press Enter, the following screen will
appear:
Enable SNMP-traps ? (y/n) [y]:
Type 'y' and press Enter, or just press Enter to enable SNMP Traps, type 'n' and press
Enter to disable SNMP traps. The SNMP configuration menu appears.
Select '5' in the SNMP configuration menu and press Enter, the following screen
appears:
Please input the new NMS IP address (A.B.C.D):
When a valid secure IP address (es) for SNMP management workstation is entered,
press Enter to return to the SNMP configuration menu.
Selecting '6' in the SNMP configuration menu will return to the Setup main menu.

3.3.6 Exiting Setup Configuration Mode

Select '5' in the Setup main menu to exit the Setup configuration mode without saving
the configurations made.
Selecting '6' in the Setup main menu exits the Setup configuration mode and saves
the configurations made. This is equivalent to running the Write command. For instance, if
under the Setup configuration mode, the user sets a Telnet user and enables Telnet
service, and selects '5' to exit Setup main menu. User will be able to configure the switch
through Telnet from a terminal.
When exiting the Setup configuration mode, the CLI configuration interface appears.
Configuration commands and syntaxes will be described in detail in later chapters.
DCS-3950 series Ethernet switch manual
22