Installing The Exb-Moss - Korg TRITON Extreme Manual

4 At a slant, press the DRAM SIMM firmly all the way into
the slot, and raise it to the vertical position until the
catches of the slot click into the locking holes of the
DRAM SIMM. When doing so, pressing the catches of the
slot apart to the left and right will help the board go in
smoothly.
2. Tilt up vertically.
Catch
5 Reversing the procedure by which you opened the sam-
ple memory (RAM) slot cover, reattach the cover and fas-
ten it with the screw.
6 When all steps have been completed, turn on the power
and make sure that the DRAM SIMM has been installed
correctly. ("Checking after installation" ☞p.320)
Removing an DRAM SIMM
• Spread the catches of the slot apart to the left and right,
and (after removing the stoppers from the catches) tilt
the DRAM SIMM and pull it out.
If you wish to remove the rear DRAM SIMM board, you
must first remove the forward DRAM SIMM.
When you spread the catches of the slot apart, the
DRAM SIMM may pop out vigorously and fall into an
opening (inside the instrument). Please be careful.
Catch
322
1. Firmly press in at an angle.
DRAM SIMM
Front
DRAM SIMM
Front

Installing the EXB-MOSS

Before you perform the installation, be sure to read the fore-
going section "Safety precautions" and "Please note when
installing an option board/memory."
While performing the installation, be careful of any
sharp or pointed edges of the TRITON Extreme or the
option board.
You must leave the AC power cable disconnected until
you have completed all steps of installing the option
board.
1 You will need a "+" (plus) screwdriver, and some maga-
zines or other material (to prevent damage to the joystick
and knobs etc.: see diagram below).
2 Turn off this instrument, and disconnect the AC power
cable and any other cables by which other devices are
connected.
3 Make sure that the sample memory (RAM) slot cover is
closed and fastened.
4 As shown below, place four books or stacks of magazines
on your work surface to prevent damage to the valve
cover, joystick, or knobs, and place the instrument upside
down on top of them.
Place at each corner to avoid
the valve cover, joystick or knobs
LOCK UNLOCK
View from below
EXB-MOSS cover
When you turn over the instrument, be careful not to
lose your balance and drop the instrument.
5 Open the EXB-MOSS cover.
• 61 key or 76 key model
Using a screwdriver, remove two screws from the EXB-
MOSS cover, raise the cover, and pull it out of the slit.
When raising the cover, pull it out without forcibly
pushing it backward.