Timbre; Realtime Control Knobs - Korg TRITON Extreme Manual

4–2a: Top Velocity, Top Slope, Bottom Slope,
Bottom Velocity
Top Velocity
Specifies the maximum velocity value that will sound each
timbre 1–8.
Top Slope
Specifies the number of velocity steps over which the origi-
nal volume will be reached, starting from the Top Velocity.
0: The volume will be at the original value from the top
velocity.
120: The volume will decrease as the velocity approaches the
top velocity.
Bottom Slope
Specifies the number of velocity steps over which the origi-
nal volume will be reached, starting from the Bottom Veloc-
ity.
0: The volume will be at the original value from the bottom
velocity.
120: The volume will decrease as the velocity approaches the
bottom velocity.
Bottom Velocity
Specifies the minimum velocity value that will sound each
timbre 1–8.
How volume will change according to keyboard location
Volume
Bottom Velocity
"Top Velocity" and "Bottom Velocity" settings can also
be input by holding down the [ENTER] key and play-
ing a note on the keyboard.
4–3: MOSS Setup
This page is displayed when the EXB-MOSS option has been
installed. (☞EM)
48
Velocity
Bottom Slope Top Slope
Top Velocity
(MOSS)
4–4: Controller
Here you can set the Combination mode functions of the
[SW1] key, [SW2] key, and the B-mode functions of REAL-
[1...127]
TIME CONTROL knobs [1]–[4].
1–1a
[0...120]
4–4a
4–4b
[0...120]
4–4a: Panel Switch Assign
These settings assign the function of the [SW1] and [SW2]
keys ("SW1, SW2 Assign List" ☞p.279).
Since the function assignments of the [SW1] and [SW2] keys
made for the program assigned to each timbre are not valid
inside of a combination, they must be newly set using these
[1...127]
parameters.
SW1 (SW1 Assign)
SW1 Mode
SW2 (SW2 Assign)
SW2 Mode
☞Program P1: 1–4a
4–4b: Realtime Control Knobs B-Assign
These settings assign functions (mainly various control
changes) to the B-mode of the REALTIME CONTROL knobs
[1]–[4] ("Realtime Control Knobs B–Assign List" ☞p.280).
The functions you specify here will be controlled when you
operate the REALTIME CONTROL knobs [1]–[4] in B-mode.
Since the REALTIME CONTROL knob [1]–[4] function
assignments made for the program assigned to each timbre
are not valid inside a combination, they must be newly set
using these parameters.
Knob 1-B
Knob 2-B
Knob 3-B
Knob 4-B
☞Program P1: 1–4b
(Control)
[Off, ..., After Touch Lock]
[Toggle, Momentar y]
[Off, ..., After Touch Lock]
[Toggle, Momentar y]
[Off, ..., MIDI CC#95]
[Off, ..., MIDI CC#95]
[Off, ..., MIDI CC#95]
[Off, ..., MIDI CC#95]
0–1A