Korg TRITON Extreme Manual page 231

Output Level
Sets the output level
Src
e
Selects the modulation source for the output level
Amt
Sets the modulation amount of the output level
Low Cutoff [Hz]
Sets the center frequency for Low EQ (shelving type)
f
Gain [dB]
Sets the gain of Low EQ
Mid1 Cutoff [Hz]
Sets the center frequency for Mid/High EQ 1 (peaking type)
Q
g
Sets the band width of Mid/High EQ 1
Gain [dB]
Sets the gain of Mid/High EQ 1
Mid2 Cutoff [Hz]
Sets the center frequency for Mid/High EQ 2 (peaking type)
Q
h
Sets the band width of Mid/High EQ 2
Gain [dB]
Sets the gain of Mid/High EQ 2
Direct Mix
Sets the amount of the dry sound mixed to the distortion
i
Speaker Simulation
Switches the speaker simulation on/off
Wet/Dry
Sets the balance between the effect and dry sounds
Src
j
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
a: Wah
The Wah parameter switches the wah effect on/off.
a: Sw
This parameter sets how the wah effect is switched on and off via
the modulation source.
When "Sw" = Moment, the wah effect is usually turned off. It is
turned on only when you press the pedal or operate the joystick.
When a value for the modulation source is less than 64,
"off" speed is selected, and when the value is 64 or higher,
"on" is selected.
When "Sw" = Toggle, the wah effect is switched between on and
off each time you press the pedal or operate the joystick.
The switch will be turned on/off each time the value of the
modulation source exceeds 64.
b: Wah Sweep Range, b: Wah Sweep Src
This parameter sets the sweep range of the wah center frequency.
A negative value will reverse the direction of sweep. The wah cen-
ter frequency can be controlled by the modulation source speci-
fied in the "Wah Sweep Src" parameter.
d: Drive, e: Output Level
The degree of distortion is determined by the level of input signal
and the setting of "Drive". Raising the "Drive" setting will cause
the entire volume level to increase. Use the "Output Level"
parameter to adjust the volume level. The "Output Level" param-
eter uses the signal level input to the 3-Band EQ. If clipping occurs
at the 3-Band EQ, adjust the "Output Level" parameter.
d: Pre Low-cut
Cutting the signal in the low range before it is input to the Distor-
tion will create a sharp distortion.
g: Q, h: Q
These parameters set the bandwidth of each equalizer. The higher
the value, the narrower the band becomes.
220
007: St. Parametric 4EQ
0...50
☞
,
Off...Tempo
This is a stereo 4-band parametric equalizer. You can select
–50...+50
peaking type or shelving type for Band 1 and 4. The gain of
Band 2 can be controlled by dynamic modulation.
20...1.0kHz
Stereo In - Stereo Out
Left
–18...+18dB
300...10.00kHz
0.5...10.0
☞
Right
–18...+18dB
500...20.00kHz
0.5...10.0
☞
a
–18...+18dB
b
0...50
c
Off, On
d
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
e
f
g
h
i
b: Band1 Type, c: Band4 Type
Selects a filter type for Band 1 and 4.
(Stereo Parametric 4-Band EQ)
Band1 Band2 Band3 Band4
PEQ PEQ
Trim
LEQ
LEQ
Trim
PEQ PEQ
D -mod
Trim
Sets the input level
Band1 Type
Selects the type of Band 1
Band4 Type
Selects the type of Band 4
Band2 Dynamic Gain Src
Selects the modulation source of the Band 2 gain
Amt [dB]
Sets the modulation amount of Band 2 gain
Band1 Cutoff [Hz]
Sets the center frequency of Band 1
Q
Sets the bandwidth of Band 1
Gain [dB]
Sets the gain of Band 1
Band2 Cutoff [Hz]
Sets the center frequency of Band 2
Q
Sets the bandwidth of Band 2
Gain [dB]
Sets the gain of Band 2
Band3 Cutoff [Hz]
Sets the center frequency of Band 3
Q
Sets the bandwidth of Band 3
Gain [dB]
Sets the gain of Band 3
Band4 Cutoff [Hz]
Sets the center frequency of Band 4
Q
Sets the bandwidth of Band 4
Gain [dB]
Sets the gain of Band 4
Wet/Dry
Sets the balance between the effect and dry sounds
Src
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
3dB
+Gain
Band4 Type=Shelving High
Band4 Type=Peaking
0dB
Band1 Type=Shelving Low
Band1 Type=Peaking
–Gain
3dB
Band1 Cutoff
Wet / Dry
PEQ PEQ
HEQ
HEQ
PEQ PEQ
Wet / Dry
0...100
Peaking, Shelving-Low
☞
Peaking, Shelving-High
☞
Off...Tempo
☞
–18...+18dB
☞
20...1.00kHz
0.5...10.0
☞
Fx:006
–18.0...+18.0dB
50...10.00kHz
0.5...10.0
☞
Fx:006
–18.0...+18.0dB
☞
,
300...10.00kHz
0.5...10.0
☞
Fx:006
–18.0...+18.0dB
500...20.00kHz
0.5...10.0
☞
Fx:006
–18.0...+18.0dB
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Parametric 4EQ - Band1, Band4 Type
Band4 Cutoff