4-3: Vel Z; 4-5: Moss; 4-7: Controller; Each Track - Korg TRITON Extreme Manual

4–3: Vel Z 1–8
(Vel Zone T01–08)
4–4: Vel Z 9–16
(Vel Zone T09–16)
Here you can set the Top/Bottom Velocity parameters to
specify the range of velocities that will be sounded by tracks
1–16, and Top/Bottom Slope specify the range over which
the volume will be adjusted.
These settings do not affect MIDI transmission/recep-
tion. All note data that is received will be recorded into
the internal sequencer, and all note data from the inter-
nal sequencer or from the keyboard will be transmitted.
4–1a
0–1a
0–1b
0–3a
4–3a
4–3(4)a: Top Velocity, Top Slope, Bottom Slope,
Bottom Velocity
Top Velocity
Specifies the maximum velocity that will be sounded by
each track 1–16.
Top Slope
Specifies the range of values over which the volume will be
adjusted from the top velocity until the original volume is
reached.
Bottom Slope
Specifies the range of values over which the volume will be
adjusted from the bottom velocity until the original volume
is reached.
Bottom Velocity
Specifies the minimum velocity that will be sounded by
each track 1–16.
You can also enter a value for these parameters by play-
ing a note while you hold down the [ENTER] key.
4–5: MOSS 1–8
(MOSS T01–08)
4–6: MOSS 9–16
(MOSS T09–16)
This page is displayed when the EXB-MOSS option has been
installed. (☞EM)
4–7: Controller
Here you can set the functions that the [SW1] key, [SW2] key,
and the B-mode functions that the REALTIME CONTROL
knobs [1]–[4] will have in Sequencer mode.
When these switches or knobs are operated during
recording, the MIDI messages that you assign here will
be recorded.
0–1a
0–1b
4–7a
0–1
4–7b
4–7a: Panel Switch Assign
Assigns functions to the [SW1] and [SW2] keys ("SW1, SW2
Assign List" ☞p.279).
Since the functions assigned to these switches by the pro-
gram assigned to each track will no longer be valid, you can
make new assignments here.
[1...127]
SW1 (SW1 Assign)
SW1 Mode
SW2 (SW2 Assign)
[0...120]
SW2 Mode
☞Program P1: 1–4a
4–7b: Realtime Control Knobs B-Assign
[0...120]
Here you can set the B-mode functions (mainly various con-
trol changes) that the REALTIME CONTROL knobs [1]–[4]
will have in Sequencer mode ("Realtime Control Knobs B–
Assign List" ☞p.280). The functions you specify here will
[1...127]
operate when you rotate the REALTIME CONTROL knobs
[1]–[4] in B-mode.
Since the functions assigned to these knobs by the program
assigned to each track will no longer be valid, you can make
new assignments here.
Knob 1-B
Knob 2-B
Knob 3-B
Knob 4-B
☞Program P1: 1–4b
(Controller Setup)
[Off, ..., After Touch Lock]
[Toggle, Momentar y]
[Off, ..., After Touch Lock]
[Toggle, Momentar y]
[Off, ..., MIDI CC#95]
[Off, ..., MIDI CC#95]
[Off, ..., MIDI CC#95]
[Off, ..., MIDI CC#95]
0–1
77