Table of Contents
Advertisement
Getting started
Battery installation and charging
Install the battery, as shown below.
screen indicates the battery status (see the following table). If necessary,
place the handset in the telephone base or charger to charge the battery.
For best performance, keep the handset in the telephone base or charger
when not in use. The battery is fully charged after ten hours of continuous
charging.
See the table on page 108 for battery operating times.
If the screen shows Place in charger and
handset without interruption
enough charge to use the telephone for a short time.
summarizes the battery charge indicators and actions to take.
Battery indicators
The screen is blank, or
shows Place in charger
and
(flashing).
The screen shows
Low battery and
(flashing).
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment. Insert
the supplied battery
with the label THIS
SIDE UP facing up, as
indicated.
Once you have installed the battery, the
for at least 30 minutes to give the handset
Battery status
Battery has no or very
little charge. The handset
cannot be used.
Battery has enough charge
to be used for a short time.
Battery is charged.
7
flashes, you need to charge the
The following table
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone base or
charger when not in use.
Step 2
Align the cover flat
against the battery
compartment, then
slide it upwards until
it clicks into place.
- Quick Links:
- Delete Call Block Entry
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CL82114 and is the answer not in the manual?
Questions and answers
What to do when blocked calls cannot be added to. How to make more room for more blocking
To add a blocked call on the AT&T CL82114:
1. Press MENU/SELECT on the handset when it is not in use.
2. Use qCID or pDIR to scroll to Call block, then press MENU/SELECT.
3. Press MENU/SELECT to choose Block list.
4. Use qCID or pDIR to scroll to Add new entry, then press MENU/SELECT.
5. When the screen displays ENTER NUMBER, use the dialing keys to enter the number.
The system can store up to 20 blocked numbers. To make room for additional blocks, you must delete existing entries by accessing the Block list and removing unwanted numbers.
This answer is automatically generated