Battery Installation And Charging - AT&T BL102-3S Quick Start Manual

Getting started

Battery installation and charging

Battery installation and charging
Once you have installed the battery, the screen indicates the Once you have installed the battery, the screen indicates the
battery status (see the following table). For best performance, keep battery status (see the following table). For best performance, keep
the handset in the telephone base or charger when not in use. The the handset in the telephone base or charger when not in use. The
battery is fully charged after ten hours of continuous charging. See battery is fully charged after ten hours of continuous charging. See
the table in the Technical specifications
the table in the
battery operating times. battery operating times.
Battery indicators
The screen is blank, or
shows Put in charger
and (flashing).
The screen shows
Low battery and
(flashing).
The screen shows
HANDSET X.
Step 1
Plug the battery connector securely into the socket inside the
handset battery compartment. Insert the supplied battery with the
label THIS SIDE UP facing up, as indicated.
Technical specifications section on page 97 for
Battery status
Battery has no or
very little charge. The
handset cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
section on page 97 for
Action
Charge without
interruption
(at least 30 minutes).
Charge without
interruption
(at least 30 minutes).
To keep the battery
charged, place it in the
telephone base or charger
when not in use.
10