Table of Contents
Advertisement
Answering system
About the answering system
Call intercept
While screening a call, you can stop recording and speak to the caller by pressing
PHONE/
.
FLASH
Base ringer
Press pVOLUME or qVOLUME on the telephone base to adjust the ringer
volume when the telephone is not in use.
You hear a sample of the ringer while adjusting the volume. The telephone
base announces, "Base ringer is off," when you set the volume to 0.
Temporarily turning off the message alert tone
If the message alert tone is turned on, the telephone base beeps every
ten seconds when there are new messages. Pressing any telephone base
key (except /HANDSET LOCATOR) temporarily silences the message
alert tone.
However, if you press a key at the telephone base to silence the message
alert tone, the telephone base will also perform the corresponding key
function. For example, if you press X/DELETE when in idle mode to
temporarily turn off the message alert tone, there is a voice prompt directing
you to press X/DELETE again to delete all old messages. The message alert
tone is temporarily off. Only press X/DELETE a second time if you wish to
erase all old messages in your answering system.
The message alert tone resumes when you receive another message.
73
- Quick Links:
- Delete Call Block Entry
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CL82114 and is the answer not in the manual?
Questions and answers
What to do when blocked calls cannot be added to. How to make more room for more blocking
To add a blocked call on the AT&T CL82114:
1. Press MENU/SELECT on the handset when it is not in use.
2. Use qCID or pDIR to scroll to Call block, then press MENU/SELECT.
3. Press MENU/SELECT to choose Block list.
4. Use qCID or pDIR to scroll to Add new entry, then press MENU/SELECT.
5. When the screen displays ENTER NUMBER, use the dialing keys to enter the number.
The system can store up to 20 blocked numbers. To make room for additional blocks, you must delete existing entries by accessing the Block list and removing unwanted numbers.
This answer is automatically generated