Answering system
Message playback
Options during playback
When a message is playing, you can adjust the playback volume, skip, repeat,
pause or delete the message.
When messages are playing on the telephone base:
Press pVOLUME or qVOLUME to adjust the message playback volume.
•
•
Press /S�IP to skip to the next message.
/REPEAT to repeat the message. Press twice to hear the
•
Press
previous message.
•
Press X/DELETE to delete the message.
/
•
Press
PLAY
When messages are playing on the handset:
•
Press q
/VOLUME or p
CID
playback volume.
Press EQ
•
•
Press 6 to skip to the next message.
•
Press 4 to repeat the message. Press twice to hear the previous message.
•
Press
/DELETE to delete the message.
MUTE
•
Press 5 or
OFF
•
Press
/SPEA�ER
SPEA�ER to switch between speakerphone mode and
handset mode.
PHONE/
•
Press
then
press
MENU
the caller's number is available. If the dialing format used is not correct,
then use the following option to choose the correct dialing format before
calling back the caller.
•
Press
/SELECT to pause playback and show the caller ID information
MENU
if available. From here, you can press
or press # (pound key) repeatedly to show the desired dialing option
(page 52), then press
caller. If you do not call back within ten seconds, message playback
resumes automatically.
NOTE: The equalizer stays on the same settings until you change it by pressing EQ .
/STOP to stop the playback.
DIR
to adjust the message playback audio quality.
/CANCEL to stop the playback.
to stop playback. The screen shows Call back?,
FLASH
/SELECT or
/SELECT or
MENU
/ VOLUME to adjust the message
PHONE/
to call back the caller if
FLASH
/CANCEL to resume playback,
OFF
PHONE/
75
to call back the
FLASH