Table of Contents
Advertisement
Appendix
Deregistering handsets
You may need to deregister your handsets if:
•
You have 12 registered handsets and need to replace a handset.
-OR-
•
You wish to change the designated handset number of your
registered handsets.
You must first deregister ALL handsets, and then register each handset you
wish to use again, one at a time.
Please read carefully through all the instructions on this page before
beginning the deregistration process.
Deregister all handsets from the telephone base
In addition to the cordless handsets, this operation will also deregister all
cordless headsets registered to your telephone base.
1. Make sure that all handsets are out of the telephone base and chargers
before you begin deregistration.
2. Press and hold
telephone base for about ten seconds (until the
IN USE light starts to flash). Release
/HANDSET LOCATOR.
3. Immediately press
IN USE light is still flashing. (If the light stops
flashing, start again with Step 1.)
4. It takes up to ten seconds to complete the deregistration process. Before
registering the handset again, wait for the cordless handset screen to
display To register HS, see manual.
5. To register the handset(s) to the telephone base again, follow the
registration instructions on pages 81-82.
NOTES:
•
If the deregistration process fails, you may need to reset the system and try again. To reset,
unplug the power from the telephone base and plug it back in.
•
You cannot deregister the handsets if any other system handset is in use.
•
Even if the battery is depleted, you can still deregister the handsets by following the steps
mentioned above. After the handset is charged for at least ten minutes, the screen shows
To register HS, see manual.
/HANDSET LOCATOR on the
/HANDSET LOCATOR while the
83
- Quick Links:
- Delete Call Block Entry
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CL82114 and is the answer not in the manual?
Questions and answers
What to do when blocked calls cannot be added to. How to make more room for more blocking
To add a blocked call on the AT&T CL82114:
1. Press MENU/SELECT on the handset when it is not in use.
2. Use qCID or pDIR to scroll to Call block, then press MENU/SELECT.
3. Press MENU/SELECT to choose Block list.
4. Use qCID or pDIR to scroll to Add new entry, then press MENU/SELECT.
5. When the screen displays ENTER NUMBER, use the dialing keys to enter the number.
The system can store up to 20 blocked numbers. To make room for additional blocks, you must delete existing entries by accessing the Block list and removing unwanted numbers.
This answer is automatically generated