Call Sign Programming - Icom IC-E80D Instruction Manual

6
DV MODE PROGRAMMING

Call sign programming

Four types of current call sign memory are available; "MY" (my
call sign=your own call sign) "UR" (your call sign=other sta-
tion call sign) "RPT1" (access repeater call sign) and "RPT2"
(linked repeater call sign). Each call sign can be programmed
with up to 8 characters.
In addition, "MY" can store up to 6 call signs, and "UR" can
store up to 60 call signs in the call sign memory. Up to 300
repeater call signs can be stored in the repeater list.
D Your own call sign programming
Your own call sign must be programmed for both digital voice
and low-speed data communications (including GPS trans-
mission).
q Enter "MY" in call sign screen.
MENU CALL-S
(Push [MENU
• MY call sign screen is displayed.
w Push [ ](2) or [ ](8) to select the desired call sign mem-
ory, "MY1" to "MY6."
36
MY
]), (Push [ ](2)/[ ](8), then push [ ](5).)
e Push [ ](6) to enter call sign programming mode.
• The 1st digit blinks.
r Push [ ](2) or [ ](8) to select the desired character or
code.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
t Repeat step r to enter your own call sign.
• Up to an 8 digit of call sign can be set.
• If an unwanted character is entered, push [ ](6) or [ ](4) to
select the character, then push [CLR](1) to erase the selected
character, or push and hold [CLR](1) for 1 sec. to erase all char-
acters following the cursor.
• To program a note (up to 4 characters, for operating radio type,
area, etc.), go to step y, otherwise go to step i.
y Push [ ](6) several times to set the cursor beside "/" indi-
cation.