Selecting Memory/Bank Name Indication - Icom IC-E80D Instruction Manual

9
MEMORY/CALL CHANNELS
[EXAMPLE]: Programming the bank name "AIR" into the
scan edge channel 3A.
During memory mode, rotate
to select scan edge channel 3A.
Push and hold
for 1 sec.
Enter select memory write mode.
Push
to select "B NAME* 2 ."
* 1 S NAME can be set for scan edge channels only.
* 2 B NAME can be set for bank assigned channels only.
98
Rotate to enter "A,"
then push .
Enter "I" and "R"
with and .
Push and hold
for 1 sec. to program.
Select "M NAME" or "S
1
NAME* " when program-
ming the memory name or
the scan name, respectively.
Selecting memory/bank
name indication
During memory mode operation, either the programmed
memory name or bank name can be displayed.
q Push [M/CALL] to select memory mode.
w Push and hold [M.N](6) to select display indication type
from memory name, bank name and OFF.
• While pushing and holding [M.N](6), rotating [DIAL] is also
available. (Name indication OFF
Bank name indication)
Name indication OFF
[DIAL]
Memory name indication
Bank name indication
NOTE: The programmed scan name is displayed during
the programmed scan selection.
Memory Name indication
Push
Channel
indication
disappears
Bank channel is
displayed.