Table of Contents
Advertisement
11
DIGITAL MODE OPERATION
■ Digital mode operation
The IC-V82/U82 with optional UT-118
erated for digital voice mode and low-speed data operation
for both transmit and receive. It can also be connected to a
GPS receiver (compatible with an RS-232 output/NMEA for-
mat/4800 bps) and transmit/receive position data.
■ Call sign programming
Four types of call sign memories are available for your own
call sign "myC," other station call sign "yUC," nearest repeater
call sign "R1C" and another zone's repeater call sign "R2C."
Each call sign memory can store up to 6 call signs, and each
call sign programmed up to 8 characters.
D D Your own call sign programming
Your own call sign must be programmed for both digital voice
and low-speed data communications (including GPS trans-
mission).
q Push [A•
] and [0•
FUNC
push [Y Y ] or [Z Z ] several times to select the call sign select
mode.
• "myC" appears.
42
can be op-
DIGITAL UNIT
] to enter
OPT
OPTION SET MODE
w Push and hold [0•
lect the desired call sign channel.
e Push [Y Y ] to select call sign programming mode.
• The 1st digit blinks and channel indication stops blinking.
r Rotate [VOL] to set the desired character or code.
• Push [Z Z ] or [Y Y ] to move the cursor to left or right, respectively.
t Push [Y Y ] to select 2nd digit, then rotate [VOL] to select
the desired character or code.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming your own call sign.
y Push [0•
] to save the call sign.
OPT
u Rotate [VOL] to select an another channel from "C1" to
"C6."
i Repeat steps w to u to program your own call sign channels.
, then
NOTE: All digital (DV) mode operation/settings require an
optional UT-118
does not indicate any items for the digital (DV) mode de-
scribed in this section.
Requires Optional UT-118
] for 1 sec. then rotate [VOL] to se-
OPT
. A transceiver without UT-118
DIGITAL UNIT
Advertisement
Table of Contents
