Repeater Name Programming (R-Name); Repeater Call Sign Programming (Call S - Icom IC-E80D Instruction Manual

6
DV MODE PROGRAMMING

Repeater name programming (R-NAME)

q Push [ ](5) to enter the repeater name programming
state.
• Repeater name programming screen is displayed.
• The 1st digit blinks.
w Push [ ](2) or [ ](8) to select the desired character, num-
ber, symbol or space.
• The selected character blinks.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• Push [CLR](1) to erase the selected character, or push and hold
[CLR](1) for 1 sec. to erase all characters following the cursor.
e Repeat step w until the desired repeater name is pro-
grammed.
• Up to an 8 digit name can be set.
r Push [ ](5) to program the repeater name and exit the
state.
44

Repeater call sign programming (CALL S)

q Push [ ](5) to enter the repeater call sign programming
state.
• Repeater call sign programming screen is displayed.
• The 1st digit blinks.
w Push [ ](2) or [ ](8) to select the desired character, num-
ber or symbol ('/' only).
• The selected character blinks.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• Push [CLR](1) to erase the selected character, or push and hold
[CLR](1) for 1 sec. to erase all characters following the cursor.
e Repeat step w until the desired repeater call sign is pro-
grammed.
• Up to an 8 digit call sign can be set.
r Push [ ](5) to program the repeater call sign and exit the
state.