Logging Measurement Data And Image Data - Omron Z302-E1-03 User Manual

7-4 Logging Measurement Data and Image Data

There are two ways to log data. Data can be temporarily saved in memory inside the Sensor (called recent
results logging) or large amounts of data can be saved in SD cards or other external media (called file logging).
The amounts of data that can be logged are given in the following table.
Logged data
Measurement data (Measured val-
ues and calculation results)
Image data (Measured values and
calculation results)
Logging All Data (File Logging)
Large amounts of measurement and image data can be saved in files in external memory (SD cards or computer).
FQ Vision Sensor
Saved for
each
measurement
*1: Image data and measurement data can be logged in the same way as for the Touch Finder by installing the PC Tool for FQ.
System Configuration: p. 20
Note
Only the data for the Sensor that is currently being displayed will be logged even if more than one Sensor is con-
nected.
If multiple sensors are displayed, or if the most recent NG sensor is displayed, only the results of the sensor that was
displayed before changing to the other sensor monitor screen will continue to be logged. Simultaneous logging of the
results of multiple sensors is not possible.
Setting the Data To Be Logged
You can select the data to be logged.
[In/Out] − [Log setting]
1
Press the data for which to change the logging pa-
rameter.
2
Change the logging parameter and then press [Back].
110

Logging Measurement Data and Image Data

Recent results logging
1,000 measurement values max.
20 images max.
Touch Finder
Image logging file
Data logging file
SD card
Computer*1
Hard disk drive
File logging
Up to the capacity of the external memory
FQ User's Manual