Omron Z302-E1-03 User Manual page 137

Changing the Judgement Output ON Conditions
The ON condition for the OR signal or the OR0 to OR31 signals can be set to be output when the judgement
results are OK or when they are NG. The default setting is when they are NG.
Settings
[In/Out] − [I/O setting] − [I/O terminals] − [Output] − [Output polarity]
Item
Output polarity OK: ON
NG: ON (default)
Changing the Polarity of the BUSY Output
The Sensor turns ON the BUSY output signal during measurements and other processing to indicate that a
measurement trigger cannot be received. The polarity of the BUSY signal can be reversed so that it is ON only
when a trigger signal can be received.
Settings
[In/Out] − [I/O setting] − [I/O terminals] − [Output] − [BUSY polarity]
Item
BUSY polarity BUSY: ON (default)
READY: ON
Important
All timing charts in this manual show the operation of the BUSY signal at the default setting. If you change the
polarity of the BUSY signal, take this into consideration when reading the timing charts.
Changing the BUSY Output Condition
The end timing of the BUSY signal can be changed.
[In/Out] − [I/O setting] − [I/O terminals] − [Output] Tab Page − [BUSY output]
Item
BUSY output Measurement (default)
Data logging
Image logging
Result display
136
Controlling/Outputting in Parallel
Description
The output is turned ON if the judgement is OK.
For the overall judgement, the output is turned ON if all judgements are OK.
The output is turned ON if the judgement is NG.
For the overall judgement, the output is turned ON if even one judgements is NG.
Description
The BUSY signal is ON while the Sensor is processing data.
The BUSY signal is ON while the Sensor can receive a trigger signal.
Description
The BUSY signal turns OFF when the measurement is completed.
The BUSY signal turns OFF when data logging is completed.
The BUSY signal turns OFF when image logging is completed.
The BUSY signal turns OFF when the result display is completed.
FQ User's Manual