Wiring - Omron Z302-E1-03 User Manual

2-4 Wiring

Wiring the Sensor
Connect the I/O Cable to the I/O Cable connector located at the bottom of the Sensor.
Important
Cut off lines that are not required so that they do not come into contact the other signal lines.
Classifi- Signal
cation
Power Power supply
supply (24 V)
GND
Inputs TRIG
IN0 to IN5
Outputs OUT0 (OR)
OUT1 (BUSY)
OUT2 (ERROR)
Note
The assignments of I/O signals can be changed.
Section 8 Communications with External Devices: p. 125
28

Wiring

FQ-WD0@@
I/O Cable
Application
These terminals are for the external power supply (24 V).
Important
Wire the power supply separately from other devices. If the wiring for other devices is placed
together or in the same duct as the wiring for the Vision Sensor, the influences of electromagnetic
induction may cause the Sensor to malfunction or may damage it.
This terminal is the trigger signal input.
These are the command input terminals.
By default, this is the OR output signal (overall judgement).
The assignment can be changed to an individual judgement signal from OR0 to OR31.
By default, this is the BUSY output signal.
The assignment can be changed to an individual judgement signal from OR0 to OR31.
By default, this is the ERROR output signal.
The assignment can be changed to an individual judgement signal from OR0 to OR31.
Brown
Power supply
Blue
GND
Black OUT0 (OR)
Orange
OUT1 (BUSY)
OUT2 (ERROR)
Light blue
Pink
TRIG
Gray IN0
Green
IN1
Red IN2
White IN3
Purple
IN4
Yellow IN5
FQ User's Manual