Omron Z302-E1-03 User Manual page 108

Displaying a Saved Image
You can display an image that was saved in internal memory in the Sensor or in an SD card. This can be done
to configure inspection items or to check measurements using saved images.
(Setup Mode)
1
Press .
2
Images in the Sensor's built-in memory: Press [Log].
Images on the SD card: Press [File].
3
Press the [Back] Button to return to the [Display] Dis-
play.
Note
Refer to the following information for the procedures to save images.
Logging Measurement Data: p. 110
Updating the Display and Measurement Results Only for NG Measurement Results
In Run Mode, you can specify updating the display of the image and measurement results only when the
measurement result is NG.
(Run Mode)
1
Press .
2
Press [Last NG image].
3
Press [Back].
Change the following setting to display the last NG image after restarting.
(Setup Mode or Run Mode) - [TF Settings] - [Startup display] - [Display update mode]
1
Press [Last NG image].
FQ User's Manual
107
Display Functions