Omron Z302-E1-03 User Manual page 26

Mounting to DIN Track
Installation Procedure
1
Press the slider on the Touch Finder to the top.
2
Hook the clip at the top of the Touch Finder on to the DIN
Track.
3
Press the Touch Finder onto the DIN Track until the bottom
clip clicks into place.
Important
• Attach End Plates (sold separately) on the sides of the Touch Finder on the DIN Track.
• If other devices will be installed next to the Touch Finder on the same DIN Track, make sure that sufficient space is
kept between the devices as indicated on previous page.
• Always hook the clip at the top of the Touch Finder on the DIN Track first. If the lower clip is hooked on first, the
Touch Finder will not be mounted very securely.
Removal Procedure
1
Pull down on the slider on the Touch Finder.
2
Lift the Touch Finder at the bottom and remove it from the
DIN Track.
Mounting to a Control Panel
The Touch Finder can be mounted on a panel using the FQ-XPM Panel Mounting Adapter.
Important
• Always turn OFF the Touch Finder power before attaching or detaching the Panel Mount Adapter. Attaching or
detaching with the power turned ON may cause a failure.
1
Set the Touch Finder in the Panel Mount Adapter.
FQ User's Manual
2
3
1
3
2
1
Installation
25