Network Technologies ENVIROMUX-SEMS-16 Installation And Operation Manual page 69

NTI SERVER ENVIRONMENT MONITORING SYSTEM
2. The window should now display the following text, indicating that the board is ready to receive new Firmware.
Please, wait...
RAM based FTP Server ready.
3. From a computer connected through the LAN (this could be the same computer, connected at the "Console" port and to the
LAN) , open a DOS command window and type the following:
Note: If this is being done through Telnet, simply open a second command window.
C:\>FTP [ENVIROMUX IP address]
4. The following prompt will appear;
220 NET+OS 6.3 FTP server ready.
User (192.168.3.83:(none)):
Press <Enter>
5. At the "ftp>" prompt, type "bin" and press <Enter>
ftp>bin
The following will display:
200 Type set to I.
ftp>
6. Enter the following command:
C:\>put C:\<file_path>\<firmwarefilename>.bin
where file_path is the location of the firmware file.
7. When the transfer has started, the following message will appear:
200 PORT command Ok.
150 About to open data connection.
8. When the transfer is complete (should take approximately 30 seconds depending on the connection speed), the following
message will appear:
226 Transfer complete
ftp: 914628 bytes sent in 28.16Seconds 32.48Kbytes/sec.
ftp>
9. When the transfer is completed, type "quit" and press the <Enter> key to exit the ftp program.
C:\>quit
10. The HyperTerminal window in the connected terminal will now display the following text:
FTP: Flash download complete.
Resetting system in 3 seconds.
(ex: default IP is 192.168.1.21)
The press <Enter>.
62